| 混凝土密封固化剂施工工序说明 |
| 添加时间：2018/8/31 17:43:35 浏览次数： |
| （1）清洁地面，保持洁净，表面干燥。 (1) clean the floor, keep it clean and dry. （2）将HI HARD混凝土密封固化剂直接均匀地洒于地坪表面，用长毛推刷来回推动，使固化剂均匀渗入约30－45分钟(具体视当时气温等情况而定)。 (2) HI HARD concrete sealant is sprayed directly and evenly on the surface of the floor, pushed back and forth with a long hair brush, so that the curing agent penetrates evenly for about 30-45 minutes (depending on the temperature and so on). （3）当地坪表面的固化剂变得滑稠时，在地面洒少量清水（约固化剂用量的1/3），并用长毛推刷均匀推开，并可用多功能刷地机配百洁垫（白色）进行研磨，促使地面二次渗入，渗入时间同上(约30－45分钟)。 (3) When the curing agent on the surface of the ground becomes slippery and thick, sprinkle a small amount of water (about 1/3 of the amount of curing agent) on the ground, push it away evenly with a long hair brush, and grind it with a multi-functional brush machine and a white mat to make the ground infiltrate twice, the infiltration time is the same (about 30-45 minutes). （4）当表面再度变得滑稠时，用清水彻底清洗整个地面，随后用吸尘器将污水及残留的混凝土密封固化剂彻底吸干净。（注：必须清理干净残留的固化剂） (4) When the surface becomes slippery and thick again, clean the whole ground thoroughly with clean water, and then use a vacuum cleaner to absorb the sewage and residual concrete sealant completely. (Note: must clean up residual curing agent). （5）若需抛光，待固化剂反应3-7天后，用多功能研磨机加配重配上1000、2000、3000目树脂片进行研磨抛光。 (5) If polishing is required, after 3-7 days of curing agent reaction, a multi-functional grinding machine is used to grind and polish 1000, 2000, 3000 mesh resin sheets. |
| 上一页 混凝土密封固化剂就是针对混凝土起尘起砂研发的 |
| 下一页 混凝土密封固化剂施工方法 |
Copyright © 技术支持：遨游网络